Electrical Requirements - Black & Decker BH1607 Manuel D'instructions

SAFETY INFORMATION
12. A heater has hot and arcing or sparking parts inside. Do not use it in the
areas where gasoline, paint, or flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or
injury to persons.
14. Always plug heaters directly into a wall outlet/receptacle. Never use
with an extension cord or relocatable power tap (outlet/power strip).
15. his heater draws 12.5 amps during operation. To prevent overloading a
circuit, plug it into a dedicated power outlet.
16. The output of this heater may vary and its temperature may become
intense enough to burn exposed skin. Use of this heater is not
recommended for persons with reduced sensitivity to heat or an inability
to react to avoid burns.
17. Don't leave the heater on unattended.
SAVE THESE INSTRUCTIONS

ELECTRICAL REQUIREMENTS

This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit into a polarized outlet
only one way. If the plug does not fit into the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician.
WARNING: Do not attempt to modify the plug in any way.
NOTE: Neither BLACK+DECKER nor the dealer can accept any liability for
damage to the product or personal injury resulting from failure to observe
the electrical connection procedures.
WARNING: To reduce the risk of electric shock, do not use with an
WARNING – RISK OF FIRE
It is important the plug fits tightly into the wall outlet.
If the plug does not fit securely and appears loose, it should not be used.
Have a licensed electrician replace the receptacle.
Page 4
HOUSEHOLD USE ONLY
extension cord.