Daikin REYQ72AATJ Serie Manuel D'opération page 17

• Table 1 "Inspection Cycle" and "Maintenance Cycle" Lists
Name of Main Part
Compressor
Electric motor (fan, damper, etc.)
Printed circuit boards
Heat exchanger
Sensor (thermistor, etc.)
Remote controller and switches
Drain pan
Expansion valve
Electromagnetic valve
FAN
Note
This table indicates main parts.
See the maintenance and inspection contract for details.
*1
The maintenance cycle durations are for appropriate budgetary maintenance planning.
The maintenance cycle indicates the recommended length of time before the need for maintenance work may arise due to
normal wear and tear for a system under normal use that has undergone recommended inspection and regular maintenance.
Contact your local dealer for detailed estimate and inspection/service planning.
Shortening of "maintenance cycle" and "replacement cycle" needs to be considered in the following cases.
1. When used in hot, humid locations or locations where temperature and humidity fluctuate greatly.
2. When used in locations where power fluctuation (voltage, frequency, wave distortion, etc.) is high.
(Cannot be used if it is outside the allowable range.)
3. When installed and used in locations where bumps and vibrations are frequent.
4. When used in bad locations where dust, salt, harmful gas or oil mist such as sulfurous acid and hydrogen sulfide may be
present in the air.
5. When used in locations where the machine is started and stopped frequently or operation time is long. (Example: 24 hour
air-conditioning)
„Recommended replacement cycle of wear-out parts
[The cycle is not the same as the warranty period.]
• Table 2 "Replacement Cycle" Lists
Name of Main Part
Air filter
High efficiency filter
(Optional accessory)
Fuse
Crankcase heater
Note
This table indicates main parts.
See the maintenance and inspection contract for details.
*1
The replacement cycle durations are for appropriate budgetary replacement planning.
The replacement cycle indicates the recommended length of time before the need for replacement work may arise due to normal wear and tear
for a system under normal use that has undergone recommended inspection and regular replacement.
Contact your local dealer for detailed estimate and inspection/service planning.
English
Inspection Cycle Maintenance Cycle*1
20,000 hours
20,000 hours
25,000 hours
5 years
5 years
1 year
25,000 hours
8 years
20,000 hours
20,000 hours
Outside : 10 years
Indoor : 13 years
Inspection Cycle Replacement Cycle*1
5 years
1 year
1 year
10 years
8 years
13