Schumacher Electric SPI15 Manuel Du Propriétaire page 10

17. TROUBLESHOOTING
PROBLEM
Battery connectors do
not spark when touched
together.
The charger will not turn on
when properly connected.
I cannot select a language
on the display.
Green LED is lit and the
display shows ANALYZING
BATTERY.
Green LED is flashing and
the display shows CHARGE
ABORTED-BAD BATTERY.
The display shows
CONNECT CLAMPS.
18. SPECIFICATIONS
Input ............................................................................................. 230V AC~50/60Hz, 2.5A
Output ............................................................................................................... 12V
Ingress Protection rating ..............................................................................................IP20
19. LIMITED WARRANTY
WARRANTY TERMS AND CONDITIONS
Schumacher Electric Corporation (the "Manufacturer") or the resellers authorized by
the Manufacturer (the "Reseller") warrant this Charger (the "Product") for two (2) years,
according to the following stipulations. Any and all warranties, other than the warranty
included herein, are hereby expressly disclaimed and excluded to the fullest extent
permissible under applicable law. Legislation may imply warranties or conditions or
impose obligations on Manufacturer which cannot be excluded, restricted or modified in
relation to consumer goods.
Consumer End-User Warranty
Any claims under this warranty must be communicated to Reseller within 2 months after
discovery of the non-conformity.
POSSIBLE CAUSE
The charger is equipped with an
auto-start feature. It will not supply
current to the battery connectors
until a battery is properly connected.
The connectors will not spark if
touched together.
AC outlet is dead.
Poor electrical connection.
Press the button for 5 seconds to
select a language:
(EN→ DE→ FR→ NL→ ES→ IT).
The charger needs to check the
condition of the battery.
The battery is too large for the
charger.
The battery voltage is still below
10V after 2 hours of charging.
The clamps are not making a good
connection.
The fuse is bad.
•
10
No problem; this is a normal
condition.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
cord for loose fitting plug.
No problem; this is normal.
The green LED will be lit when the
charger is checking the condition of
the battery. This is normal.
You need a charger with a higher
amp rate.
Have the battery checked.
Check for poor connection at
battery and frame.
Replace the in-line fuse for the ring
connector.
•
SOLUTION
15A