BedJet VET-800NA Manuel D'utilisation page 9

IMPORTANT INSTRUCTIONS: USER OPERATING MANUAL
Maintenance
The only maintenance required for the BedJet VET is periodic replacement of the HEPA filter and
periodic cleaning of the washable HEPA prefilter.
HEPA PREFILTER CLEANING: The washable black foam prefilter is installed on top of the HEPA
filter and helps extend the life of your HEPA filter. Clean the HEPA lifetime washable pre‐filter
every 2 months or when visually dirty. Simply remove the black foam prefilter from HEPA filter (it
is attached to front of HEPA filter with Velcro) and clean under running water. Reinstall prefilter
when dry and gently push the grill until it snaps back in place.
HEPA FILTER REPLACEMENT: The HEPA filter is recommended to be replaced every 400 hours or
every 6 months of regular use. The BedJet VET contains a HEPA filter service clock. At 400 hours
the BedJet VET will give an audible alert reminder to replace the HEPA filter.
HEPA FILTER SERVICE ALARM RESET: Hold down the gear icon button on the remote control while
simultaneously pressing the OFF button. The HEPA filter service alarm should now be reset for an
additional 400 hours. The service alarm can also be reset from the Bluetooth App.
Once grille is opened, pull strap
to slide filter assembly out.
Revision 1.0
MODEL SKU: VET‐800NA
Push both filter buttons (on either side of
grille) in the direction indicated to release
front air grille for easy access to filters.
Filter
Strap
Peel black prefilter away from HEPA filter to
separate for cleaning and/or replacement.
Prefilter
P a g e | 9
HEPA
Filter