BedJet VET-800NA Manuel D'utilisation page 3

IMPORTANT INSTRUCTIONS: USER OPERATING MANUAL
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Do not attempt to defeat this safety feature.
6. DO NOT plug device into any other cord connected device, such as a power strip, surge
protector, multiple outlet adapters, or outlet‐type air fresheners. The use of such devices may
create a fire hazard. Plug unit directly into a wall outlet only.
7. Always plug this device directly into a wall outlet/receptacle. Never use with an extension cord
or relocatable power tap (outlet/power strip).
8. Do not operate this device with a damaged cord or plug, or after the device malfunctions or
has been dropped or damaged in any manner. Return device to authorized service facility for
examination, electrical, or mechanical adjustment or repair.
9. To disconnect device, make sure device is not currently operating in heat or cool mode, press
the Main Power Button, then remove plug from outlet.
10. Always unplug device when not in regular use. Unplug power cord before servicing or moving
the device. WARNING: DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF
DISCONNECTING POWER WHEN SERVICING OR MOVING THE DEVICE. ALWAYS UNPLUG THE
POWER CORD.
11. Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as
it may cause an electric shock, fire, or damage the device. Do not block or tamper with the
device in any manner while it is in operation.
12. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not place unit
on soft surfaces, like a bed, where openings may become blocked.
13. Always place the device on a stable, flat, level surface when operating, to avoid the chance of
the device overturning. Locate the power cord so the device or other objects are not resting on
it. Do not run cord under carpeting. Do not route cord under furniture or appliances. Arrange
cord away from traffic area and where it will not be tripped over.
14. This device has hot and arcing or sparking parts inside. Do not use the BedJet in areas where
gasoline, paint, or flammable liquids or flammable gases are used or stored. It must NOT be
used in potentially dangerous locations such as flammable, explosive, chemical‐laden, or wet
atmospheres.
15. This device is not intended for use in wet or damp locations. This device is NOT INTENDED for
use in bathrooms, laundry areas, and similar indoor locations. Never locate the device where it
may fall into a bathtub or other water container. Do not immerse BedJet in water.
16. This device is not intended for use as a room air heater.
17. Do not use device outdoors.
18. Keep the cord away from heated surfaces.
19. Do not operate where aerosol (spray) products are being used or in oxygen rich environments.
Revision 1.0
MODEL SKU: VET‐800NA
P a g e | 3