Transporting And Unpacking - Summit FF68CSS Manuel Du Propriétaire

 If the appliance is transported in a
horizontal position, the oil from the
compressor may leak into the cooling
circuit. For this reason, allow the
appliance to rest in a vertical position for
12 hours before turning it on, so that the
oil flows back into the compressor.
 Remove the external packaging, remove
the protective plastic film from the surface
of the appliance (if used) and clean the
external parts of the appliance with a
cleaner designed for this purpose. Do not
use steel wool or any coarse agents,
which could irreparably damage the
surface of the appliance. Carefully remove

Transporting and unpacking

After unpacking you MUST allow this appliance to stand
upright for at least 2 hours to allow the lubricant and
refrigerant to drain back into the compressor and stabilize.
Failure to do so may adversely affect performance and the
lifetime of this unit.
all papers and adhesive tape from the
appliance, doors and other parts packed
in polystyrene. Remove documents and
accessories from inside the appliance.
 The packaging material is recyclable and
is marked with a recycling symbol. For
disposal, follow the local regulations.
Packaging materials (plastic bags,
polystyrene parts, etc.) present a possible
source of danger and must be kept out of
the reach of children.
 Carefully inspect the appliance. If you
discover any faults, stop the installation
and contact the vendor.
CAUTION
4