Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
The light will not turn on.
The fuse blows or circuit breaker trips
when light is turned on.
FCC Notice
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiver antenna.
Increase the separation between the equipment and receiver.
Install the product onto on a circuit different from that to which the receiver is
connected.
Consult with the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes made to the electronics circuit will void this equipment's
compliance with Part 15 of the FCC Rules and should not be operated.
Solution
Make sure the power supply is on.
Test or replace the switch.
Check the wiring.
Make sure the grey and purple dimming
wires are not touching each other.
Check the wire connections.
7
Publicité
Table des Matières
