Envirolite EVTR24BL64PD Guide D'utilisation Et D'entretien page 5

Installation (continued)
3
Connecting the supply wires
NOTE: If you have electrical questions
consult your local electrical code for
approved grounding methods.

Remove the access plate located on
end of the fixture (A). Locate the black
fixture wire and the white fixture wire.

Remove one knockout in the access
plate.

Thread the power supply wires
through the knockout hole in the
access plate.

Connect the black supply wire and the
white supply wire to the quick
connector.

Connect the supply ground wire to the
fixture ground wire using a wire nut.
4
Connecting the dimming wires

Remove the access plate located on the
end of the fixture (A). Locate the purple
fixture wire and the grey fixture wires.

If you decide not to connect a dimmer, cap
off the purple and grey fixture wires
individually with a wire nut and replace the
access plate when finished.

If you decide to connect a dimmer,
remove one knockout in the access plate.

Thread the dimming wires through the
knockout hole in the access plate.

Connect the purple and grey fixture wires
to corresponding wires of the wall 0-10V
dimmer. Replace the access plate when
finished.
DIMMING CONNECTIONS
PURPLE DIMMING
WIRE
GREY DIMMING
WIRE
5
NO DIMMING
PURPLE FIXTURE WIRE
GREY FIXTURE WIRE
PURPLE FIXTURE
GREY FIXTURE
A
A
WIRE
WIRE