Safety 1st Glow & Go Mode D'emploi page 2

WARNING
PLEASE READ THE FOLLOWING WARNINGS AND ALL ASSEMBLY
INSTRUCTIONS CAREFULLY BEFORE USING THE GLOW & GO MONITORING
SYSTEM. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
TERMS USED IN WARNINGS: The term "Receiver" corresponds to "Parent's
Unit" and the term "Transmitter" corresponds to "Baby's Unit" in the rest of this
instruction booklet.
• The Glow & Go Monitoring System is not intended to replace responsible and
proper parental supervision.
• Check your child's activity at regular intervals as this monitor will not alert
parents to the silent activities of a child.
• Before using your Glow & Go Monitoring System:
- Read and follow all instructions carefully.
- Read and observe all warnings on the product and in this
instruction booklet.
• To prevent entanglement with the adapter cord, NEVER PLACE THE CORD IN
OR NEAR A CRIB OR PLAYPEN. DO NOT place the Receiver anywhere its AC
adapter cord is within reach of children.
• ALWAYS KEEP THE TRANSMITTER, RECEIVER AND AC ADAPTERS OUT OF
REACH OF CHILDREN.
• This product is not intended to be used as a medical monitor and its use
should not replace adult supervision.
• It is essential to check reception regularly. Please see the Testing Reception
section for complete instructions.
• The Glow & Go Monitoring System is intended for indoor use only.
• NEVER use the Transmitter or Receiver near water. For example, do not use
near a bathtub, bathroom sink, laundry tub, kitchen sink, in a wet basement,
etc.
• Always unplug the AC adapters from wall outlets during long periods
of non-use.
• Position the Transmitter, Receiver and AC adapters to allow adequate
ventilation and prevent these components from overheating.
• To prevent overheating, keep the Transmitter, Receiver and AC adapters away
from heat sources such as radiators, heat registers, stoves or other
appliances (including amplifiers) which produce heat. Also keep these
components out of direct sunlight.
• Use only the AC adapters provided. Use of any other adapters may damage
the Transmitter and/or Receiver. Plug the AC adapters into standard
household current only (120V AC outlet)! To prevent entanglement and
overheating, DO NOT use extension cords.
• The AC adapters may become slightly warm to the touch during operation.
This is normal.
• Position the AC adapter cords so that they are not walked on or pinched by
items placed upon or against them, paying particular attention to cords at AC
2
All manuals and user guides at all-guides.com