Safety 1st Glow & Go Mode D'emploi page 6

Operating Your Glow & Go Monitoring System
To Set Up the Baby's Unit:
WARNING
• To prevent entanglement, only mount the Baby's Unit in a location where it and its
AC adapter cord are OUT OF REACH OF CHILDREN.
• To prevent entanglement and overheating, NEVER use an extension cord.
3. Battery Use: Unscrew the screw at the
back of the Baby's Unit (Figure B). Pull
off the battery door. Insert 9 volt battery.
Secure the door with the screw.
4. AC Use: Connect the AC adapter into the
back of the Baby's Unit (Figure B). Connect
the AC adapter into a power outlet.
CAUTION: DO NOT use an adapter that did
not come with this product.
To Use the Baby's Unit and Parent's Unit:
5. Turn the Parent's Unit and the Baby's Unit On.
Adjust the channel on Parent's Unit to match
the channel on Baby's Unit (Figure C).
6. Adjust the volume by turning the button
on the side of the Parent's Unit (Figure C).
7. Check to be sure the Parent's Unit and
Baby's Unit are on the same channel
(Figure C).
Soft Glow:
8. For your convenience, the Soft Glow and
digital room temperature have been designed
to work independently of the audio monitor.
Soft Glow can be turned on/off even when
the audio monitor is off and the digital temp
will always be displayed when the Baby's Unit
is powered on.
To turn light on, press the top (antenna) of
the Baby's Unit (Figure D). Press again to
turn light off. The Soft Glow light has a
15-minute automatic shut off.
NOTE: The Soft Glow light has a long
lasting bulb, which is not replaceable.
6
All manuals and user guides at all-guides.com
B
Screw
C
On/Off
Channel Selector
D
Press
Switch
AC
Adapter
Volume
Control