Channel Specifications; Microphone Specifications; Installation - Senrun EP-980 Manuel Utilisateur

Channel specifications

Frequency range
Carrier Frequency Range
Stability
Deviation
Dynamic range
SIN Ratio
T.H.D.
Frequency Response
Wireless Microphone Capsule Type
Wireless Transmitter Ratio
Transmitter Battery

Microphone specifications

MODEL
Carrier frequency range
Pre-programmed Frequency
Frequency stability
Frequency response
Antenna
Battery
Weight

Installation

1. To get the best position to set up is away from ground (1m-1.5m) to get best position. Option with tripod stand (ST-3B).
2. Adjust the volume to the minimum position by any volume control.
3. When electricity power display indicator show in Full that means the rechargeable batteries are fully charge, the light indicator
will be solid green.
4. The receiver of this unit can be changed frequencies which is high quality product with easy operation.
5. The Extension speaker system must connected before insert into 6.3mm external jack (output power must above 50W speaker).
14
UPL-83
600-960MHz
Preset 16 Channels
<0.005%
100Hz-15KHz( ± 3dB)
External antenna
1.5v x2 or 1.2V x2(AA UM-3)
100g
UHF PLL
UHF 600-960MHz
±0.005%
±40KHz, with level Limiting circuit controlled
80dB overall
>90dB
<0.5%
100Hz-15KHz(±3dB)
Dynamic Capsule or Condenser Capsule
Approx 10mW
AA No 3 Batteries (2 pcs)
Transmitter Model
Outlood design
Microphone capsule
Carrier Frequency range
Frequency Stability
Antenna
RF Output Power
Currency Consumption
Battery
Weight
UH-816
Handheld
DynamicICondenser
(EP-980I900 device condenser)
600-960MHz
±0.005%
Built in
10mW MAX.
100mA ±10mA
1.5V x 2 Pecs
230g