Operation; Carrying The Tool; Lcd Screen; Bluetooth - Greenlee GATOR EK6IDCVX11 Mode D'emploi

Operation

1. Wear appropriate Personal Protective Equipment,
including eye, face, head and arm protection and
other PPE as required by your employer, and/or as
appropriate for the job.
2. Press the locking flange and open the crimping head.
3. Insert the properly assembled connector into the
crimping head.
4. Close the crimping head.
5. Ensure arm's length distance between tool and user
(Fig. 3, pg. 12) then pull the trigger to make the crimp.
Note: Trigger activates white LED work light which
remains on for 10 seconds after trigger is released.
6. Hold the trigger down until the crimping tool
achieves pressure relief, which is accompanied by
an audible "pop".

LCD Screen

This tool has an LCD screen that displays information
about the tool. Turn on the screen by inserting the
battery and tapping the trigger.
In normal operation, cycle through the various displays
Display LCD Screen
0
P
1
P
INFO
FW:
2
123456AB001
CURRENT USER : 1
SINGLE CLICK
MRS+
3
NEXT SERVICE
4
5000 OPS
730 DAYS
TOTAL:
T=
5
Q=
n=
Bluetooth/I-Press App
This tool has Bluetooth capability that allows the tool
to communicate with the Greenlee i-press App on your
smart device.
1. Install the "i-press Klauke Software Solutions"
app from the App Store or Google Play. Open
the app on your smart device and select the
Greenlee option.
Greenlee Tools, Inc.
Gator Insulated Battery-Powered In-Line Crimper
®
Information Shown

Bluetooth

status, battery charge, current pressure, max. pressure. Press and hold both
®
PSI
buttons to change units, select with right button, and confirm by jogging the tool.
PSI
2.0
Firmware version, serial number
Current user. Press and hold both buttons to change user and toggle between single
click and double click operation. Change the user and operation with the right button
and confirm the selection by tapping the trigger. Selecting single click will allow the user to
operate the tool with one trigger pull. Selecting double click will require the user to press
the trigger twice within 1/2 second to operate the tool.
Cycles and days until next service.
Elapsed operating hours (T), Ah used (Q), and number of cycles (n) since date of
0.0h
0.0Ah manufacture.
0
7. The ram will return automatically to the starting
position.
The process can be interrupted at any moment by
releasing the trigger. By actuating the retract button,
the ram will return to the starting position. If you do not
hear the sound of the relief valve or the ram does not
automatically retract, the crimp is not complete.
Note: This tool is not designed for continuous use. After
100 cycles allow the tool to cool for 15 minutes.
Do not twist work piece or tool during operation. Failure
could result.

Carrying the Tool

The carrying ring and carrying strap are for carrying
only. Never hang or suspend the tool by the strap.
using the left and right buttons on either side of the
screen.
The LCD screen will also display error codes in the
event of abnormal operation. See pg. 17 for error code
troubleshooting.
2. Switch on the Bluetooth function on your smart
device and activate the tool to establish a
connection.
3. The app will allow you to create projects,
personalize your tool, and display tool pressure
readings, battery charge, the last service date, and
more. Instructions how to use the app are shown in
the i-press app itself; alternately, request MA6864
brochure from any Greenlee distributor.
14
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070