Specifications; Operation - Greenlee CTR200 Manuel D'instructions

Specifications

Weight .....................................................................................................19.9 lb (9.0 kg)
Opening .......................................................................................... 4" (101 mm) square
Capacity ...................................................................................................200 lb (90 kg)

Operation

Figure 2
• Based on the width of the cable tray, use the twist
handle to position the adjustable leg where needed,
and tighten to fix the leg in place.
• Use the spring-loaded pull pin to position the rollers
along the perforated tube, in 1" increments, where
desired to best route cable in the tray.
• Set the assembly on the cable tray where desired, as
shown in Figure 1.
• Fasten the roller to the cable tray as shown in
Figure 2. Secure the roller to the tray by releasing the
ratchet strap, pulling the strap underneath the tray,
attaching the hook to the mount on the opposite leg,
and ratcheting until tight.
Greenlee Tools, Inc.
Figure 1
• To remove cable from the square rollers, pull one of
the two spring-loaded release pins and pivot the lower
roller open, as shown in Figure 3. Be sure to support
the weight of the cable when pivoting the roller, as
improper use may bend the frame of the unattached
roller.
• To remove the roller from the cable tray, pinch and
pull down the ratchet strap's release mechanism. Use
caution when releasing the hook from its mount, as
the auto-retractable strap may cause injury if let go
with personnel in the vicinity.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
CTR200
Figure 3