VS Uno-M-Step Mode D'emploi page 4

Adjustment.
Adjusting table heights.
Tools required: Two Allen keys WAF 5 (model 22499).
The tables are adjusted to a height prespecified in the job
order. Subsequent height adjustment:
- Release and remove the two sleeve nuts (1) in the side
frame.
- Remove load from the table and pull out the two
threaded pins with sleeve nuts (2) .
- Adjust in the hole grid to the desired table height
according to DIN-EN-1729-1 in the size categories
3 to 7 (59, 64, 71, 76 or 82 cm) and reinsert the two
threaded pins with sleeve nuts (2) .
- Screw in both sleeve nuts (1) again. Note: There must
now be no play between the outer and inner tubes.
Caution!
Make sure the screwed connection is firmly seated!
- Proceed to adjust the second table leg in the same way.
4
(2)
(1)