JVC KENWOOD PKT-23LF Mode D'emploi page 19

Channel
Number
13
14
15
16
Press the PF-2 key to switch between Volume Adjustment mode
•
and Channel Select mode.
2 To make a call, press and hold the PTT switch, then speak into
the microphone using your normal speaking voice.
• Hold the microphone approximately 1.5 inches (3 to 4 cm) from
your mouth.
3 Release the PTT switch to receive.
Note:
◆ When the battery pack voltage becomes too low, transmission will
stop and an alert tone will sound. (Low Battery Warning: While
operating the transceiver, the Low Battery Warning sounds an alert
tone every 30 seconds and the LED indicator blinks red when the
battery needs recharged or replaced.)
◆ Even when setting the volume to 0, the transceiver will continue to
emit beep sounds and channel announcements.
◆ Continuously transmitting when the transceiver becomes too hot
will cause the output power to decrease and may eventually stop
transmission. Stop transmitting for a while to allow the transceiver to
cool down.
◆ You may sometimes hear noise during communications, depending on
the caller's transceiver.
LED Voice Announcement
Purple
"Thirteen"
"Fourteen"
"Fifteen"
"Sixteen"
Number of times LED
blinks
1
2
3
4
19