FAR RT1049W Manuel D'utilisation page 19

ENGLISH
Please Note: If the appliance is switched off you
must wait at least 5 minutes before restarting the
appliance or re-inserting the plug into the wall
outlet. This is to allow the protection device in
the compressor to reset.
If the compressor fails to start correctly remove the
plug and wait for 5 minutes before you try again
then the compressor should restart normally.
The storage temperature may be affected by:
– The room temperature
– How often the door is opened
– How much food is stored
– Position of the appliance
When you set the correct temperature, all these
factors mentioned above shall be taken into
account.
TEMPERATURE INDICATE
In order to help you get the correct adjustment
of your device, it is equipped with a temperature
gauge placed in the coldest area.
For the proper storage of food in your
refrigerator and in particular in the coldest area,
make sure that "OK" appears in the temperature
indicator.
GB-10
The symbol on the left side indicates
the location of the coldest area of your
refrigerator. It defines the height of this
area.
If "OK" is not displayed, the average
temperature in this area will be
very high. You ought to adjust the
thermostat to a colder setting.
For every modification of your thermostat, you
are supposed to wait for the stabilization of the
temperature inside the unit before proceeding,
if necessary, to a new setting. Do change the
position of the thermostat gradually and wait at
least 12 hours before re-checking.
NOTE: after charging the device for fresh food
or after repeated or prolonged door openings,
it is normal that the inscription "OK" does not
appear in the temperature indicator.
Wait at least 12 hours before readjusting the
thermostat.
ENGLISH
GB-11