Dip Switch Configuration - Hotpoint AH11E07D Manuel D'utilisation Et Instructions D'installation

Dip Switch Configuration

REMOVING THE FRONT PANEL
Dip switches controls are located behind front panel,
through an opening below the control panel. To
access,remove front panel.
DIP SWITCHES CONFIGURATIONS
configurations and functions of each dip switch position.
(Factory default switch positions shown)
No. UP (ON)
Fan Continuous Run for Cooling
NOTE:
Wall Thermostat Enable
control the unit.
Low temp. Protection (optional)
motor and electric strip heat will turn on and warm
temperature is satisfied.
Electric Heat Only (for heat pump unit only)
2. Then lift up
1.
bottom to release
it from the tabs .
DIP SWITCH CONFIGURATION TABLE
Fan Cycle for Cooling
Dip switches are accessible without opening the
Unit must be powered OFF to effectively change dip
switch status.
1 2 3 4 1 2 3 4 1 2
DOWN (OFF)
to select set point range.
Heat and Cool Fan CON/CYC Dip-switches
while the unit is in heating and cooling mode.
CON(Continuous)
when the temperature setting has been satisfied. This
switch helps to maintain the room temperature closer
to the thermostat setting.
CYC(Cycle)
This setting allows the fan to cycle on and off with the
compressor or electric heater. The fan stops a short
time after the temperature setting is satisfied.
Setpoint Temperature Limits
UP(ON)
1 2 3 4
DOWN(OFF)
Heating type
Temperature display type
Control type
Setpoint limit 1
Setpoint limit 2
Fan CON/CYC for heating
Fan CON/CYC for cooling
Low temp. Protection
Remarks
49-5000041 Rev. 5