Standard Mount; Installing The Mount - Canarm TRI-LITE HVLS Serie Mode D'installation

TRI-LITE HVLS SERIES FANS

STANDARD MOUNT

A Standard Mount package is used with all Tri-Lite HVLS Fans
assemblies (except "Wood" Beam Mounting). See Figure 1.
Standard drop mounts of approximately 1', 2' and 4' are available.
The package includes:
(2) mfg "I" Beam clamps
(2) mfg "I" Beam spacers (may or may not be required for assembly)
(1) Upper Pivot Plate
(1) Upper Pivot (pre-assembled)
(1) Stem for 1', 2' and 4' packages
(4) Bolts, Nuts & Washers
(1) Cable 5mm SS (Length 6.5')
(4) Cable Clamps 5mm (not shown)
NOTE: Spacer may or may not be required.
This is dependent upon the thickness of the support structure.

INSTALLING THE MOUNT

1. Sandwich the "I" Beam or OWSJ Beam between the mfg "I"
Beam clamps and the upper pivot plate. Insert the mfg "I"
Beam spacers if required.
2. Insert the bolts, washers and tighten the nylocks (Figure 2).
3. Position the safety cable as per Figure 2, loop at both ends.
4. Using a 7/16" wrench, fasten cable clamps as typical cable clamp
installation (Figure 3). Cable should be relatively snug.
TYPICAL CABLE CLAMP INSTALLATION
When placing cable clamps on the wire, it is imperative that the
U-bolt side of the clip is placed on the short turn back side and the
saddle goes on the long side (the "live" end).
EXTENSIONS
The package includes:
(1) Extension (standard 2' or 4')
(4) Bolts M14-2.0 x 36mm
(8) Washers Flat M14
(4) Nylocks M14-2.0
(1) Cable 5mm SS (Length 3.3')
(4) Cable Clamps 5mm
Depending on your assembly, your package may
include an extension. The extension with the
standard mount will make up the overall drop
length.
If a specific drop distance is required, a custom
extension may be an option and can be ordered.
NOTE: You are only allowed to use a maximum of two extensions per assembly!
TRI-LITE HVLS-M (04_29_15)
Turn back side
Live end
Cable
Turn back side
Cable live end
NOTE:
FIGURE 1
FIGURE 2
FIGURE 3
U-Bolt
Saddle
FIGURE 4
Page 4 of 13