Using The Headset; Switching On/Off The Headset; Pairing The Headset With Bluetooth Devices; How To Enter Pairing Mode - Zipy go! EARAIR Guide D'utilisateur

Using the headset

1. Switching on/off the headset

Function
Switch on
the headset
Switch off
the headset
Note: In order to save power, the headset will automatically switch off if no
devices can be connected within 5 minutes after switching on.

2. Pairing the headset with Bluetooth devices

How to enter pairing mode

Function
Enter
into
pairing
mode
Note: The pairing mode will last 2 minutes, if the headset still can't pair
with any Bluetooth devices after 2 minutes, it will switch into standby mode
automatically.

Pairing the headset with Bluetooth mobile phone

Prior to using the headset for the first time, you have to pair it with a
Bluetooth-enabled cell phone. The pairing procedures are subject to
different models of cell phones. Please refer to your cell phone user's
manual for further information. The general pairing procedures are as
follows:
1) Please keep the headset and mobile phone within 1 meter when pairing;
2) Make the headset enter into pairing mode.(Please refer to "how to enter
pairing mode");
3) Activate your mobile phone's Bluetooth function and set your mobile
phone to search for Bluetooth devices within range, and select
Operation
Press button
for 3-5 seconds,
and release it till
the blue LED is on
Press button
for 3-5 seconds,
and release it till
the red LED is on
Operation
Make sure the headset is off
firstly. Press
7-9 seconds, and release it till
the red and blue LEDs blink
alternately
LED
indicator
Blue LED is on
for 1 second
Red LED is on
for 1 second
button for
5
Indication
A long "DI"
tone
A long "DI"
tone
LED Indication
indicator
Red and Two "Du"
blue LEDs tones
blink
alternately.
tone
tone