Zipy go! EARAIR Guide D'utilisateur page 5

Before you use this Bluetooth headset, please charge the battery of EARAIR
fully.
Next time
When you hear three "DONG" tones every 20 seconds, at the same time, the
red LED blinks twice. It means the battery is low power and need to be
charged.
The charging steps are as follows:
1) Pull up the rubber cover of charging port
2) Plug the travel charger into standard AC power socket (or plug USB
cable into USB port of PC);
3) Plug the other end of charger (or charging cable) into charging port of the
headset.;
When the red LED is on, the headset is charging.
When the red LED is off, the headset is charged fully.
4) It will take about 2.5 hours to charge the headset fully.
5) Take out the charger from power socket and headset, and cover the
rubber cover.
Note: Choosing travel charger or USB cable depends on different countries
or areas and actual demands.
Warning:
1) The battery is recyclable.
2) Do not dispose of the battery in fire, as it may cause explosion.
;
4