Assembly; Operation - Hoover ONE PWR SYSTEM CORDLESS Guide De L'utilisateur

WARNING!
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF position when not in
use or carrying at your side.
If any parts are damaged or missing, please call
1-800-406-2005.
Product Assembly
See Figure 1, page 7
• Install the dirt cup onto the handheld by rocking into place
• Push the reach wand down onto the powered nozzle until it
clicks into place
• Push the handheld down onto the reach wand until it clicks
into place
• Before first use, be sure to fully charge the battery. May
take up to 3-4 hours. After charging, insert the battery into
the handheld.
Charging your Product See Figure 3, page 8
• Charge the battery fully before first use. This will take up to 3-4 hours.
Due to federal regulations, the battery does not come fully charged.
• Plug the charger into a power outlet.
• Attach the battery pack to the charger by aligning the ribs on the
battery pack to the grooves in the charger. Slide the battery pack
into the charger.
• When charging, the lights on the battery will illuminate to show the
state of charge. The light on the charger will flash.
• If the light on the charger flashes red, there is an error with the battery
or the charger. Try again or call customer service for support.
• Once charge is complete, lights on the battery and charger
will turn off.
• To remove the battery pack from the charger, press the latches and
pull up on the battery pack.
• During charging, the pack and ambient temperature should be be-
tween 32 to 86 F (5 and 30
° °
• The charger will sense if the pack, or ambient temperature, is too cold
or too hot, and will return an error code (red LED will be on) and not
charge the pack.
Using your Product See Figure 4, page 8
• Press the ON/OFF button located on the handle. The ON/
OFF button and battery level indicator lights on the
handle will illuminate when ON.
• To maximize runtime, activate Eco Mode by pressing the button on
the dashboard.
• Blade defaults to hard floor mode with a slow brush roll. For cleaning
on carpets, press the Carpet button on the dashboard.
Additional accessories available for purchase at Hoover.com
C).

ASSEMBLY

Fully assemble product prior to use.
Wall Mount Assembly
See Figure 2, page 7
• Choose the desired location for the wall mount.
• Place the mount on the wall at the desired height. Mark the wall an-
chor locations. Install the anchors and screw the mount to the wall.
• Store the vacuum by firmly pressing the unit into the wall mount
to secure.
• Always ensure the vacuum is securely locked into place.
• Accessories can be stored by sliding them onto the top of the
wall mount.

OPERATION

To reduce the risk of personal injury from moving parts,
turn the power switch to OFF and disconnect battery
pack before connecting or disconnecting accessories.
Handheld Mode See Figure 5, page 8
• Press the handheld release button. Pull to separate the handheld from
the reach wand.
• Choose an accessory.
• Push the accessory into the handheld until it clicks into place.
Cleaning Up High See Figure 6, page 8
• Press the powered nozzle release button and pull to remove the pow-
ered nozzle from the reach wand.
• Choose an accessory.
• Push the accessory into the reach wand until it clicks into place.
Not to be used for grooming a pet.
To avoid injury, particularly to face and head, keep
hair, loose clothing, fingers and all parts of the body
away from revolving brush.
WARNING!
WARNING!
CAUTION!
WARNING!
PG.4