How To Remove The Battery Pack - Voltera EV105 Manuel D'utilisation

How to remove the battery pack

Recommended tools (not included): Screwdriver.
WARNING! The pool vacuum must be disconnected from the supply mains
before removing the battery pack.
1. Place the pool vacuum on a flat surface. Use the screwdriver to unfasten
the screws on the back cover. Remove the battery from the chamber.
2. To detach the battery connection wire, press on the clip of the connector
to pull it out. NOTE: Wrap the connector immediately with insulating tape
in order to avoid any short circuit caused by the contact of both wire
terminals.
(To be carried out by authorized technician)
17