Vacuuming The Sunken Compartment Of An Automatic Slatted Cover; Cleaning The Filter Bag/Cartridge Filter - Voltera EV105 Manuel D'utilisation

Vacuuming the Sunken Compartment of an Automatic Slatted Cover

WARNING! Pay attention to all safety warnings in the manual of your
automatic slatted cover concerning this cleaning operation beforehand.
- The minimum distance required for the immersion of the vacuum into the sunken
compartment is 30cm (12in)
- Remove the duckboard and unroll the pool slat according to instructions from your
pool cover manual.
- Detach one extension of the vacuum cleaner before immersing it into the pool.
- Attach a telescopic pole (not provided) to the pool vacuum handle as instructed in the
manual.
- Power on the vacuum then align it as shown in the image above before immersion.
- Once the cleaner reaches the pool floor, parallel it to the pool length as shown above
and start vacuuming the sunken compartment.

CLEANING THE FILTER BAG/CARTRIDGE FILTER

Remark: Cartridge filter bag is not necessarily included with every model
CAUTION! Make sure the pool vacuum is OFF before cleaning the filter bag/cartridge
filter.
Washing regularly the filter bag and cartridge filter helps to maintain a good suction and
close contact between the vacuum and the pool floor during the operation.
Place the cleaner on a flat surface. Press on the cord fastener to release the bag from the
main body.
It is recommended to wash the filter bag with a water jet after each pool cleaning cycle.
Spray at an angle to get rid of the debris between the pleats of the cartridge filter. Never
use a pressure washer as it will damage the cartridges. To eliminate stubborn dirt or scum
on a clogged filter, wash the filter bag in a washing machine at 30 ˚C (86 ˚F) water
temperature. For cartridge filter, soak it in water with detergent for 2-3 hours, then rinse it
with a water jet. If brushing is deemed necessary, use only a soft brush to clean it carefully
and gently to avoid any damages.
14