Connecting/Disconnecting - Panasonic CF-VEB511 Mode D'emploi

Connecting/Disconnecting

CAUTION
Do not connect or disconnect the port replicator while the computer is powered on or in
the standby or hibernation mode.
Connecting/Disconnecting
Connecting
Power off the computer, and disconnect all cables
1
from the computer.
Connect the plug of the AC adaptor that came with
2
the computer to the DC-IN jack of the port replicator
and plug the other end into an AC outlet.
E
CAUTION
Do not use other than the specified AC adaptor (Model No. CF-AA1653A)
and AC cord.
Refer to the "Operating Instructions" accompanying computer for informa-
tion on proper handling of the AC adaptor and AC cord.
3
Remove the expansion bus connector protective cap
and place it in the cap holder to prevent its getting
lost. (The expansion bus connector protective cap is
placed in the cap holder prior to shipment from the
factory.)
4
Slide the computer onto the port replicator, align the
back of the computer with the back of the port
replicator, and then slowly lower the computer to con-
nect the expansion bus connector.
CAUTION
Do not connect the computer to a port
replicator while the computer is connected to
the AC adaptor or other cables.
Do not attempt to make connections if there
is any object between the computer and the
port replicator. Doing so could damage the
computer and the port replicator.
6