Starting Up The Iq Easy System; Explanation Of The Display; Setting Up The Iq Easy System - Simco-Ion Manager IQ Easy Manuel D'installation Rapide

5. Starting up the IQ Easy system

Switch on the Manager (and the Extension) using the on/off switch at the power input.
-
Wait until the hourglass symbol
-
- The system is now started up.

6. Explanation of the display

Buttons/symbols
Settings
Information
Active
Standby
Inactive or
incorrect entry

7. Setting up the IQ Easy system

Once a device is connected, recognized and the manager has gathered all information, most
devices will become active or inactive, depending on the start-up parameter Autorun. By default,
neutralising equipment will be activated automatically, charging equipment will go into the
standby mode. See the manual of the device, whether this Autorun parameter is present.
A connected Sensor Bar can be coupled to a neutralising bar (e.g. a Performax IQ Easy) to
operate in the Closed-Loop Feedback mode. By default, on a Sensor Bar all sensor segments
will be active.
The set point of the charging equipment must be manually set after its connection. Then the
charging equipment must also be switched on manually.
ManagerIQEasy_QM_9752103070_NL_D_GB_F_V1_0
on the display of the Manager disappears.
Background colour device
Inactive or no
communication
Active and
operating OK
Standby
Active with a
warning
Active with an
alarm
Connected device type
Nothing
connected
Neutralizing
equipment
Charging
equipment
Sensor
Detection
equipment
GB
13