Publicité
Les langues disponibles
Les langues disponibles
19. Speaker Output Jacks
The ¼-inch and Speakon™ jacks are used to connect extension speaker cabinets. All
speaker output jacks are in connected in parallel; the minimum load impedance is 4-ohms
(e.g. two 8-ohm or four 16-ohm cabinets).
20. Tweeter Defeat / Active Switch (DynaBass 400 & DynaBass 400T combos only)
The Tweeter Defeat / Active toggle switch provides you with the option of playing classic
bass tones (tweeter defeated) or more modern full-range tones with increased high
frequency definition (tweeter active). You be the judge of what sound you prefer!
21. AC Power Receptacle
The DynaBass 400 is equipped with a standard grounded IEC power receptacle. Only use the
supplied removable power cord or one that uses a minimum of 16 gauge wire.
22. Preamp Tube Replacement
Use only Yorkville Sound part number "12AX7SORTED" when replacing preamplifier tubes
as they have been specifically selected for this product. Please refer to the Service Manual
for more information.
1/4-inch T.R.S.
Phone Plug
Tip = 0°
Ring = 180°
Sleeve = Ground
Balanced 1/4-inch T.R.S. to Balanced XLR
6
XLR Plug
(Male)
Pin 1 = Ground
1
2
Pin 2 = 0°
3
Pin 3 = 180°
Publicité
