Bostitch N88RH-2MCN Manuel D'instructions Et D'entretien page 9

OPERATING YOUR N88RH-2MCN 2-IN-1 FRAMING NAILER
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE:
spectacles and face shields alone do not provide adequate protection.
IMPORTANT - READ CAREFULLY!
You and others working around you can be seriously injured by this tool if you do not follow the instructions
provided on the tool and in the operation manual. Used properly, the tool provides an easy, safe, and
efficient method for driving nails for all kinds of construction projects.
NOTE: Refer to your Operation Manual or Parts List if any of the terms used below are unfamiliar to you.
SEQUENTIAL TRIP
Your new Bostitch tool with the Sequential Trip (gray trigger):
1. Offers a positive safety advantage since it will not accidentally drive a nail if the tool is bumped against
any surface or anybody while the operator is holding the tool with the trigger pulled.
2. Allows Place Nailing without the possibility of driving a second nail on recoil.
The Sequential Trip (gray trigger) gets its name from the "sequence" required to operate the tool. To drive a
nail, the operator must first depress the trip against the work and then pull the trigger. To drive a second
nail, the operator must lift the tool from the work, release the trigger, and then repeat the above sequence.
TO AVOID SERIOUS INJURY FROM FASTENERS AND FLYING DEBRIS WHEN INSTALLING
METAL CONNECTORS WITH THE N88RH-2MCN:
• Always use the Metal Connector Attachment. (see installation instructions).
• Only use sequential trip (gray trigger).
• Use only genuine Bostitch metal connector nails.
• Use only one stick of metal connector nails at a time.
• Metal connector nails are not designed to penetrate metal. When installing metal connectors,
always place the Metal Connector Attachment Guide in the metal connector's pre-formed hole
before attempting to drive a fastener
9
Non-side shielded