Data Storage - Greenlee DML-54 Manuel D'instructions

Data Storage

In order to ...
Set the Measurement
Interval
Start Recording Data
Stop Recording Data
Review Stored Data
* If the data counter number is larger than the display's numeric capacity, the bar graph will indicate the
data counter's most significant digit. For instance, when reviewing data location 16500, the bar graph will
show "1" the display will read "6500".
follow these instructions.
Press momentarily, and the
meter will display the current
measurement interval in seconds.
Press or to change the
measurement interval. Press
again to save the new setting.
Press and hold START ||. The
meter will display Strt and will
begin to record the input.
Press and hold START ||. The
meter will display StoP and will
mark the last memory location
with an end-of-data sign.
Press START ||, or
momentarily. CALL will appear
momentarily on the display and
the icon will flash while the
stored data is displayed.
DML-54 • DML-430
Options
While recording, you may ...
• Press START || at any time to
pause the recording function.
The icon will flash and Cont
will appear on the display. Press
START || again to resume
recording.
• Press SELECT to view the data
counter*.
After storing data, you may ...
• Shut off the meter.
• Change the battery.
*While reviewing data, you may ...
• Press or momentarily to
step through the data.
• Press SELECT to toggle between
the data and the data counter*.
• Press and hold
scan through the data. Tone
indicates that the first or last
measurement is displayed.
• Press and momentarily to
view the maximum measurement.
Press them again to view the
minimum measurement.
• Press or momentarily while
holding down the HOLD button to
scan through the turning points
(the alternating high and low
points) of the data set. MAX or
MIN will flash to indicate a high
or low point.
or to quickly
11