Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RECOMMENDED AIR SUPPLY
No.
1
Air Tool
2
Air Hose
3
Quick Coupler
4
Oiler (only required for air tools with motor)
5
Pressure Regulator
OPERATION
Oil tool before each use. 4 to 5 drops of a good grade Air Tool Oil placed in
proper air pressure and CFM rating listed for this tool.
1. To set the tool to desired torque, select a nut or screw of known tightness of the same size, thread
pitch and thread condition as those on the job.
2.
Turn air regulator to low position, apply wrench to nut and gradually increase power (turn regulator to
admit more air) until nut moves slightly in the direction it was originally set. The tool is now set to
duplicate that
3.
Do not tighten nuts or screws with higher torque than allowed. Put nut or screw in the thread and start
attach several revolutions by hand. With the impact wrench tighten the screw until it rests flush against
the supporting surface.
LUBRICATION & MAINTENACE
Oil tool before each use. 4 to 5 drops Air Tool Oil placed in the air inlet is sufficient.
Use proper air pressure and CFM rating listed for this tool.
TROUBLESHOOTING
Probable Cause
Dirty or clogged air passages
Insufficient air supply
Air leakage
Worn/damaged wear & tear parts
Tool matching
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Description
tightness.
All bolts must always be checked with a torque wrench after installation.
(Insufficient power)
Flush and lubricate tool, drain air tank and supply line
Increase line pressure, make sure compressor matches tool's
air pressure and consumption needs
Use teflon tape at all fittings and joints.
Check tool for worn or damaged o-rings & seals.
Replace as necessary
Be sure you are using a tool suited for the sanding
requirements of the job at hand.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
No.
Description
6
De-Watering / Filter Unit
7
De-Watering Valve
8
Shut-Off Valve
9
Dryer / Filter Unit
10
Compressor / 11 De-Watering Valve
the
Solution
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
air inlet is sufficient. Use
Publicité
Table des Matières
