Technical Data; Air Source - BGS technic 6684 Mode D'emploi

TECHNICAL DATA

Impact Mechanism: Jumbo Hammer
Square Drive: 12.5 mm (1/2")
Free Speed: 8500 rpm
Working Torque: 27 - 231 Nm
Max. Torque (Clockwise): 325 Nm
Max. Loosening Torque (Counterclockwise): 550 Nm
Air Consumption: 113 L/min (4 CFM)
Working Pressure: 6.3 Bar (90 PSI)
Air Inlet Type: 1/4"
Recommended-Hose-Ø: 10 mm (3/8") (ID)
Noise Level: LpA: 87.9 dB (A) / LwA: 98.9 dB (A)
Vibration Level: ahd = 9.96 m/s² / K = 2.10 m/s²
Weigth: 1.16 Kg
WARNING!
Read, understand and follow all instructions and warnings before operating this tool.
Failure to do so may result in personal injury and/or property damage and will void warranty.
SAFETY ADVISES
1. Be sure air is in OFF position when connecting tool to air supply.
2. Always wear approved eye protection when using tools.
3. Use only those accessories that are designed for use with tools. For example, with impact wrenches
do not use ordinary sockets. Use
4. Be sure to disconnect tool from air supply before changing accessories, performing service on tool,
and when not in use.
5. As with any tool, use common sense when operating. Do not wear loose clothing or
become caught by moving parts, causing injury. Operate tool a safe distance from yourself and others
in the work area.
6. Follow air source manufacturers directions for connection of regulators, filters, and other accessories
to air source. Do not install quick couplers directly on tool as they put unnecessary strain on the air
inlet threads possibly causing them to wear out prematurely. Instead, install them on a short length of
air hose attached to the tool.

AIR SOURCE

Clean and dry air and a correct air pressure is recommended as air supply for this air tool.
Maximum of 90 PSI at the air tool is recommended for most air tools of this class. Check specifications
section for recommended pressure. (Depending on length of air hose and other circumstances, air
pressure at compressor may need to be increased to 100 PSI to ensure 90 PSI at the tool. Water in the air
hose and compressor tank contributes to reduced performance and damage of the air tool. Drain the air
tank and filters before each use and as necessary to keep the air supply dry. Hose length over 25" causes
loss in line pressure. Increase hose ID or increase compressor pressure to compensate the pressure
Use an in-line pressure regulator with gauge if air inlet pressure is critical.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Air Angle Impact Wrench
impact sockets for all air tools.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
If raising dust, wear a suitable mask.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 6684
jewelry that could
loss.