To Start Heater; To Restart Heater - Procom PCTT15 Manuel D'utilisation

WARNING: Attach heater in
upright position. Never attach
heater in a horizontal position.
This could lead to dangerous
flare-ups or fire.
For use with 20, 40, 60 or 100 lb. propane
cylinder (bottle).
7. Securely tighten all gas connections.
8. Open the cylinder's gas valve and check
all connections for leaks. Apply a noncor-
rosive leak detection fluid to gas joints.
Bubbles forming show a leak that must
be corrected. DO NOT USE A FLAME.

TO START HEATER

WARNING: When lighting the
heater DO NOT look over top of
heater (reflector). Stand to the
side of the heater during ignition.
Do not stand or have any part of
your body in front of the heater.
WARNING: MAKE SURE
THERE IS NO OPEN FLAME IN
THE AREA. Fully open the valve
on the propane/LP cylinder.
Read all lighting instructions before attempting
to ignite heater.
1. Turn the heater regulator knob counter-
clockwise to the HI position.
2. Place a lit match near the face of the heat-
ing element (mesh screen) of the burner
you are lighting, using the hole located on
the side of the reflector. See Figure 4.
CAUTION: Do not light at the
orifice.
3. Press button on safety valve admitting gas
to burner (see Figure 4).
WARNING: Do not press valve
button before inserting match.
4. When the gas on the face of mesh screen
lights, continue to hold valve button
pressed for 30 seconds, then release.
5. If flame goes out, wait 5 minutes and
repeat lighting procedure.
6
OPERATION
6. If heater will not light after repeated tries,
do not attempt to repair heater. Call Cus-
tomer Service toll free at 1-866-573-0674.
7. For dual burner models, repeat steps 1
through 4 to ignite the other burner.
8. After both burners or single burner, are lit,
turn heater regulator knob to the desired
heat setting (LOW, MED, HI).
Figure 4 - Lighting Heater With a Match
1. Securely close valve on propane/LP cyl-
inder.
2. Turn heater regulator knob to the OFF
position. Wait 15 minutes for heater to
cool down before handling heater.
3. Always remove heater from propane/LP
tank after each use. Do not store heater
while attached to propane/LP tank. Re-
move heater from propane/LP tank by
turning fuel connector nut clockwise.
Always store propane/LP tank outdoors.
Never store propane/LP tank in an en-
closed area.
1. Securely close valve on propane/LP cylinder.
2. Wait 5 minutes.
3. Restart following To Start Heater proce-
dure, page 5.
www.usaprocom.com
6 heat setting combinations:
Burner #1 Burner #2
LOW
MED
HI
LOW
MED
HI
Button on
Safety Valve
TO STOP HEATER

TO RESTART HEATER

OFF
OFF
OFF
LOW
MED
HI
Manual
Lighting
Hole
160220-01B