3A HEALTH CARE MAXIASPEED Manuel D'utilisation Et D'entretien page 15

knob towards "+" a higher vacuum is obtained, while turning it towards "-" a lower vacuum is obtained:
these values can be read on the vacuum gauge (1).
4. Start the appliance by switching the main switch to the "I" (ON) position (10). If the appliance is
equipped with the pedal switch, to use the same, insert the loose pedal plug into its panel socket
on the back of the appliance; switch the switch to the "I" (ON) (11) position located to the side of the
main switch (10) which permits switching on/off using the pedal switch.
5. After the application, switch of the appliance, remove the power supply cable from the current socket
and perform the cleaning operations as illustrated in the "CLEANING AND DISINFECTION OPERATIONS"
paragraph.
6. N.B.: there is a very capacious compartment on the back of the appliance for putting the power
supply cable back in after the application, and if the appliance is equipped with the pedal switch,
also for this latter.
Detach the cannula, the manual regulator and the silicon tubes which can be sterilised Ø 8 x 14 - long
from the container. Disconnect the silicon tubes which can be sterilised Ø 8 x 14 - short from the respective
containers and from the respective anti-bacterial filters and empty the container/s. We recommend
emptying the liquids collected into the biological material container.
In order to clean the accessories, rinsing them under hot running water is sufficient. Before performing
the container cleaning operations empty their content into the biological material containers and clean
them by sterilisation in an autoclave with a cycle at 121°C. The silicon aspiration tubes can be sterilised
in an autoclave with a cycle at 121°C.
During the sterilisation operations the operator must use latex gloves and suitable clothing in order not
to come into contact with any possibly contaminating substances.
The disposable anti-bacteria filter must be replaced after every application.
Never wash the appliance under water or by immersion; clean the outside of the appliance using a cloth
moistened with detergent (non abrasive).
Socket for
pedalswitch
(where foreseen).
CLEANING AND DISINFECTION OPERATIONS
PATIENT
connection
VACUUM
connection
Cable and Power supply
pedal switch socket with fuse
compartment (inspection type)
Fig. 2a
Short tube
Ø 8x14mm
Long tube
Ø 8x14mm
Fig. 2
Fig. 2b