Operation; Selector Switch - stafix Cyclic Wave B6 Mode D'emploi

Battery maintained installation
This energiser has been designed to operate safely
with a battery charger power pack.
A battery maintained installation allows the energiser
to draw its normal operating power through a battery
charger power pack connected to a mains/line power
source. This enables the energiser to continue
operating from a battery supply during a power
outage. A battery maintained installation is normally
indoors.
A battery maintained installation is recommended
where stock control is critical, for example for
controlling game, high value stock, diseased stock or
where a fence line borders a public highway. A
suitable battery charger power pack can be purchased
from your nearest Stafix stockist.
Warning! A rechargeable 12 V, lead-acid battery
must be used with a battery maintained installation.
Installing the energiser with a battery charger power pack
Warning! Before installing the energiser, ensure
the energiser is switched off.
Select a suitable place indoors for the energiser
1
and battery charger power pack.
Ensure that the energiser, battery and battery
charger power pack are out of reach of children.
The battery charger power pack should be
mounted close to a power outlet. The battery
must be level. To avoid possible damage to the
energiser ensure that the battery is at least 1 m
(3') away from and not directly below the
energiser.
Warning! Ensure there is adequate ventilation
to allow gases to disperse from the battery.
Mount the energiser on a wall. Use the template
2
printed inside the back cover of this manual.
Connect the energiser fence Earth terminal
3
(green) to the earthing system.
Connect the energiser Fence output terminal
4
(red) to the fence.
Attach the red (+) energiser clip to the positive
5
terminal of the battery, and the black (–) clip to
its negative terminal. For permanent installations,
use wire to connect the energiser to the battery.
Connect the battery to the battery charger power
6
pack.
Connect the battery charger power pack to the
7
mains/line power.

Operation

Keep this manual in a handy location.
•
Carefully read all the safety considerations in this
•
manual. See Safety Considerations on page 8.
Carefully check your installation to ensure that it
•
complies with all local safety regulations.
Ensure the Selector switch is set to Off. The
1
Power light is illuminated when the energiser is
receiving power.
Select the output setting using the Selector
2
switch. See Selector Switch on page 3.
The LED display indicates the output voltage of
the energiser. See LED display on page 4.

Selector Switch

The energiser functions according to the position of
the Selector switch. The Selector switch controls the
power output setting of the energiser.
Setting Description
Off Turns the energiser off. Keep the energiser off
while setting up your fence line to avoid
accidental shock.
Auto The energiser automatically adjusts power output
as the fence load increases or decreases.
Half Overrides the automatic adjustment and keeps
the energiser in reduced-power mode
permanently.
Full Overrides the automatic adjustment and keeps
the energiser in full-power mode permanently.
3