Samplex Power SAM-100-12 Manuel Du Propriétaire page 4

SECTION 1 | Safety
5. Loose connectors may cause overheated mating surfaces and melted insulation.
6. Remove the unit from the 12V Power Outlet when not in use.
The unit should only be used in locations that meet the following criteria:
DRY – Do not allow water and/or other liquids to come into contact with the unit.
COOL – Ambient air temperature should be between 0ºC to 40ºC. Do not place the
unit on or near a heating vent or any piece of equipment which is generating heat
above room temperature. Keep the unit away from direct sunlight. Do not block fan
suction and discharge.
VENTILATED – Keep the area surrounding the unit clear to ensure free air circulation
around the unit. Do not place items on or over the unit during operation. If the unit
over-heats, unplug it and let it cool down for 30 minutes.
SAFE – Do not use the unit near flammable materials or in any locations that may ac-
cumulate flammable fumes of gases.
!
CAUTION!
Risk of Fire. Do not replace any vehicle fuse with a rating higher than recommended
by the vehicle manufacturer. This product is rated to draw 10 amperes from a 13.8 V
vehicle outlet. Ensure that the electrical system in your vehicle can supply this product
without causing the vehicle fusing to open. This can be determined by making sure
the fuse in the vehicle which protects the outlet is rated higher than 10 amperes.
Information on the vehicle fuse ratings are typically found in the vehicle operator's
manual. If a vehicle fuse opens repeatedly, do not keep on replacing it. The cause of
the overload must be found. On no account should fuses be patched up with tin foil or
wire as this may cause serious damage elsewhere in the electrical circuit or cause fire.
4 | SAMLEX AMERICA INC.