Ec Declaration Of Conformity - JCM ACCESS-1000 Mode D'emploi

IMPORTANT ANNEX
Disconnect the power supply before handing the equipment.
In compliance with the European Directive low-voltage electrical equipment, we hereby inform users of the following requirements:
• For equipments which are permanently connected, an easily accessible circuit-breaker device must be built into the wiring system.
• This equipment must always be installed in a vertical position and firmly fixed to the structure of the building.
• This equipment must only be handled by a specialised installer, by his maintenance staff or by a duly trained operator.
• The instruction manual for this equipment must always remain in the possession of the user.
• Terminals of maximum section 3,8mm must be used for the power supply connections.
2
• Use time delayed fuses.

EC DECLARATION OF CONFORMITY

The manufacturer
JCM TECHNOLOGIES, S.A.
C/Bisbe Morgades, 46 Baixos
08500 VIC – Barcelona
SPAIN
declares herewith that the product designated below complies with the relevant fundamental requirements as per Article 3 of the
R&TTE Directive 1999/5/EG, insofar as the product is used correctly, and that the following standards apply:
Product: Controller 868,35MHz
Manufactured by: JCM TECHNOLOGIES, S.A.
Trade mark: JCM
Type: ACCESS-1000
Environment of use: Residential, commercial and light industry
Standards:
• Telecommunication EN 300 220-1 v1.3.1 (2000-09), EN 300 200-3 v1.1.1 (2000-09)
• Electromagnetic Compatibility EN 301 489-3 v1.3.1 (2001-11), EN 301 489-1 v1.3.1 (2001-09)
• Low Voltage EN 60730-1 (2000)
Vic, 20/12/04
JUAN CAPDEVILA MAS
General manager
A, B, CH, D, E, F, GB, I, IRL, IS, L, NL, P
26