Taurus Ancona Mode D'emploi page 21

produce steam.
- Wait until the coffee release pilot
light comes on, indicating that the
appliance has reached the appropria-
te temperature.
- Press the steam release button.
- Place a recipient under the steam pipe.
- Open the control for a few seconds
so that the water that has remained
in the vaporiser can be released. In a
short time steam only will start to be
released.
- Close the control and remove the
recipient.
Once you have finished using the
appliance:
- Turn the appliance off, using the on/
off switch.
- Unplug the appliance to the mains.
- Remove the water from the water tank.
- Clean the appliance
Cleaning
- Disconnect the appliance from the
mains and let it cool before underta-
king any cleaning task.
- Clean the equipment with a damp
cloth with a few drops of washing-up
liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as blea-
ch, or abrasive products, for cleaning
the appliance.
- Do not submerge the appliance in
water or any other liquid, or place it
under a running tap.
- It is advisable to clean the applian-
ce regularly and remove any food
remains.
Manual Ancona.indb 21
How to deal with lime scale incrusta-
tions:
- For the appliance to work correctly
it should be kept free of lime scale or
magnesium incrustations caused by
the use of hard water.
- To prevent this kind of problem, we
recommend the use of water with low
lime or magnesium mineralisation.
- However, if it is not possible to
use the kind of water recommended
above, you should periodically remove
the lime scale from the appliance:
- Every 6 weeks if the water is "very
hard".
- Every 12 weeks if the water is
"hard".
- To do so, we recommend the use
of the specific product Taurus Decal,
which can be found in specialised
shops and authorised technical
services.
- Homemade solutions are not re-
commended in the de-scaling of this
appliance, such as the use of vinegar.
Anomalies and repair
- Take the appliance to an authorised
technical support service if problems
arise.
Do not try to dismantle or repair
without assistance, as this may be
dangerous.
- If the connection to the mains has
been damaged, it must be replaced
and you should proceed as you would
in the case of damage.
If any anomaly is detected, check the
following table:
17/05/11 17:43