General E Z PRO 851 Manuel De L'utilisateur page 9

Trousse de gabarits à goujons de luxe
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Mark the jig locating line 15/16" above
and parallel to your doweling line (Fig. K).
Align your edge board on this line on the
surface of your work piece and clamp
both pieces (Fig. M).
4. Place the Doweling Jig on its back with
the thumbscrew toward you, and screw
the desired size drill bushing into the
right hand, inside hole (Fig. N).
(Note: this is the only bushing hole to be
used when surface doweling.)
5. With the jig still on its back, slide its top
edge to the clamped edge piece (Fig. N),
or to the marked line (Fig. O). Align the
registration points on both ends of the jig
with the extended location lines, hold or
clamp the jig firmly and drill your dowel
hole.
Re-align the E•Z Pro Jig and drill holes
for each dowel position. Insert dowels;
Assemble dry to check for fit.
Apply glue to dowel pins or
drilled holes for a permanent joint.
Once assembled, wipe away
excess glue.
9
M
N
O

Publicité

Table des Matières
loading

Table des Matières