stayer BC1200D Instructions page 10

TROUBLESHOOTING GUIDE
PROBLEM
- Power cord not firmly
plugged into outlet.
Motor does not
- Outlet damaged.
start
- Cleaner not switched
- Clogged filters.
- Dust filter needs
cleaning. (11 y 7)
Suction power
is weaker
- Dust container (1)
not in position.
- Lid not closed.
5.3 REPAIR SERVICE
Our after-sales service responds to your questions
conceming maintenance and repair ofyour product as well
as spare parts.
Exploded views and information on spare parts can also
be found under: info@grupostayer.com
Our customer consultants answer your questions
conceming best buy, application and adjustment of
productsand accessories.
DISPOSAL AND RECYCLING
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
OnlyforEC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2012/19/
UE for Waste Electrical and Electronic
Equipment
national right,power tools that are no longer
usable must be collected separately and
disposed of in an environmentally correct manner.
Subject to change wlthout notlce.
5.REGULATIONS
TECHNICAL DATA
= Rated power input
= Capacity
= Aspiration
= Diameter of the tube
CAUSE ACTION
- Plug unit firmly.
- Check the
Outlet.
- Switch on the
on. appliance.
- Clean the dust
filter.
- Close the lid
using the fixings 2
and note matching
the notches of the
lid 12.
and its implementation
ENGLISH
10
= Tube length
= Weight
=Sound power level
L
PA
=Sound pressurelevel
L
WA
=Vibration
The values givenarevalid for nominalvoltages [U]230/240
V-50/60 Hz - 110/120 V- 60Hz. For lower voltage and
models for specific countries, these values can vary.
Please observe the article number on the type plata of
your machine.The tradenamesoftheindividualmachines
may vary.
NOISENIBRATION LNFORMATION
Measuredsoundvalues determined according to EN
62841-1
Wear hearlng protectlonl
The vibration emission level given in this information sheet
has been measured in accordance with a standardised test
given in EN 62841-1 and may be used to compare one tool
with another. lt may be used for a preliminaryassessment
of exposure.
The declared vibration emission level represents the
main applications of the tool. However if the tool is used
for different applications,with different accessories or
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure leveloverthe
into
totalworking period.
An estimation of the levelof exposure to vibration should
also take into account the times when the tool is switched
off or when it is running but not actually doing the job. This
may significantly reduce theexposure leveloverthetotal
working period.
ldentify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and
the accessories,keepthe hands warm,organisationof work
pattems.
10