Operation Conditions - Panasonic CS-XE9PKUA Instructions D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

The human activity sensor will also scan for area of heat source and movement in a room.

• The human activity sensor performance is inﬂ uenced by indoor unit location, movement

speed, temperature range, etc.

• The human activity sensor may:

- mistakenly detect an object with heat source & movement similar to human, such as

pets, etc.

- mistakenly detect as non-heat source & movement if a human stays motionless for

certain period of time.

• Do not place large objects near the sensor and keep away heating units or humidiﬁ er

from the sensor's detection area. They may cause sensor malfunction.

Room Freeze Protection Function (RFP)

Room Freeze Protection function (RFP) is used in spaces that are unoccupied during the winter, for the purpose of

protecting any equipment or appliances which may be destroyed as a result of freezing temperature.

To select Room Freeze Protection

When selected, the unit will circulate the air in High mode for monitoring the temperature. When the sensor detects the

temperature drops below 46°F / 8°C the compressor/heat pump operation begins, when the temperature reaches 50°F /

10°C, the compressor stops and repeat this cycle.

ROOM FREEZE PROTECTION FUNCTION (RFP) OPERATION

When the RFP is selected, the unit will operate the fan at high speed for proper room temperature monitoring. When the

sensor detects that the room temperature has dropped below 46°F / 8°C, the compressor/heat pump operation begins.

When the room temperature reaches 50°F / 10°C, the unit shuts off, then will repeat continuously if the temperature

drops below 46°F / 8°C again.

This function may not be performed if the unit is not energized, or under a certain condition that unit is unable to operate

such as in protection mode. Please consult with the HVAC installers or professional for details.

The Room Freeze Protection function (RFP) cannot be used unless the unit is energized and set into the RFP mode.

In the advent of a power failure this mode will not function. During the RFP mode, POWERFUL OPERATION, QUIET

OPERATION and FAN SPEED selection are all disabled. Please consult with you HVAC installer or professional for

more details.