SamplexPower SAM Serie Mode D'emploi page 25

SECTION 6 |
operating threshold/
condition/ reason
protection
No Output Internal hot
due to High spot > 88°C
Temperature to 115°C
Shut Down
No output due Output power
to Over Load is > Continu-
Shut Down ous / Surge
Rating
No output due Neutral or
to Ground Fault Line con-
Shut Down nected to
Ground
No output No DC Input
Voltage due
to Blown DC
Input Fuse
For 15A breaker
SAM-2000-12, on top of the
SAM-3000-12: outlet has
No output tripped due to
from outlet to load > 1725
which load is VA/15A
connected
* On activation of protection, the Green LED will start dimming slowly and will extinguish after some time.
Protections Monitoring
& Trouble-Shooting
Green yeLLoW
LeD (6, LeD (5,
power) input
fault)
OFF* ON
ON OFF
ON OFF
OFF OFF
ON OFF
reD Buzzer
LeD (7,
fault)
OFF OFF
ON OFF
ON OFF
OFF OFF
OFF OFF
SAMLEX AMERICA INC. | 23
remedy/reset
Check ambient tempera-
ture, fan and loss of cool
replacement air .
Auto reset when hot spot
cools down 10°C to 15°C
below the threshold.
Check starting surge rating
of load. If happens with
low power CFL or SMPS, try
adding small resistive load.
If happens when inverter
is switched ON with high
capacitance load already in
ON condition, try switching
ON the load 10 sec after the
inverter has been switched
ON.
Manual Reset. Unit will latch
in shut down condition. To
reset, switch OFF the ON/
OFF Switch, wait for 3 min-
utes and switch ON again.
Check if there is Neutral to
Ground bond or Ground
Fault.
Manual Reset. Unit will latch
in shut down condition. To
reset, switch OFF the ON/
OFF Switch, wait for 3 min-
utes and switch ON again.
Check fuse in the 12V bat-
tery input line.
Remove the load and reset
the breaker (push in).
Ensure load connected to 1
outlet is < 1725 VA/15A.
Use 2 outlets in parallel if
load is > 1725 VA.