BIC Sport YAKKAIR HP 1 Guide D'utilisation page 8

ASSEMBLY /INFLATION
2. The keel : it is the structural part of the boat, and has been pre-positioned
in the factory, but it may be necessary to recentre it both in length and width
before inflation. Inflation pressure : 6,5 psi.
1
3. The floor : position it on top of the supports then inflate it to the 6,5 psi pressure.
1
Important advice
It is important, when leaving your kayak stored for a long period of time or
when exposed to direct sunlight, to release a small amount of air pressure,
so as to avoid any one of the separate components over-inflating, which can
happen with unforeseen increases in ambient pressure / temperature.
For your information, the YAKKAir HP / Nomad HP kayaks should keep a constant air
pressure in the inflated parts for up to 24 hours, as long as the ambient temperature remains
relatively constant. After this time, or as a result of significant changes in atmospheric
pressure / temperature, your kayak may lose / gain some air pressure.
Therefore, the air pressure in all components must be checked before every outing in the kayak.
P. 8
2
2
3
3