INFOSEC E4 LCD Pro TM 10k Manuel Utilisateur page 50


05: Reserved
Interface

06: Reserved
Interface

07: Reserved
Interface

08: Bypass mode setting
Interface

09: Battery backup time setting
Interface
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
49
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 11 16 AA XX 201 07
Setting
Reserved
Setting
Reserved
Setting
Reserved
Setting
Parameter 2:
OPN: Bypass allowed. When selected, the UPS will run in Bypass
mode depending on bypass enabled/disabled setting.
FBD: Bypass not allowed. When selected, it is prohibited to run in
Bypass mode under any circumstances.
Parameter 3:
ENA: Bypass enabled. When selected, Bypass mode is activated.
DIS: Bypass disabled. When selected, automatic bypass is
acceptable, but manual bypass is not allowed. Manual bypass
means users manually operate the UPS for Bypass mode. For
example, pressing the OFF button in AC mode to switch to
Bypass mode.
Setting
Parameter 3:
000~999: Set the maximum backup time from 0min to 999min.
UPS will shut down to protect battery after backup time runs out.
The default value is 990min.
DIS: Disable battery discharge protection and backup time will
depend on battery capacity.