Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Electrical and mechanical inspection of all components must be performed regularly. It is recommended
that inspection be performed monthly. Lubricate threads periodically.
CAUTION
Electrical power supply MUST BE OFF before and during installation or maintenance.
DISCONNECT primary power source and LOCK OUT. Installation and maintenance
procedure must be performed by a trained and competent electrician.
• Inspect all contact wire terminals for tightness. Discoloration due to excessive heat is an indicator
of possible problems and should be thoroughly investigated and repaired as necessary.
• Check grounding and bonding for correct installation and secure connection.
• Check gaskets for deterioration.
• Clean exterior surfaces making sure nameplates remain legible.
• Inspect clamp guide assembly and cable grip tightness to ensure proper cable gripping.
• Inspect interior parts and replace those which are broken or excessively worn.
• Check all contacts for signs of excessive arcing or burning.
WARNING
If any parts of the plug, receptacle or connector appear to be missing, broken or show
signs of damage, DISCONTINUE USE IMMEDIATELY! Do not modify these devices in any
way. Replace with new device. Failure to do so could cause serious personal injury and/or
equipment damage.
An Electrical Preventive Maintenance Program as described in the National Fire Protection Association
Bulletin NFPA No. 70B is recommended in addition to these required maintenance procedures.
FIGURE 1 • CONNECTOR- Reverse Service
POWER
(11)
CABLE
(4)
(6)
(7)
(5)
FIGURE 2 • PLUG-Reverse Service
(4)
(6)
(13)
POWER
(7)
CABLE
(11)
(8)
(5)
FIGURE 3 • INLET-Reverse Service
(16)
(14)
PD1718
(Page 2)
(3)
(12)
(9)
(1)
(2)
(8)
PLASTIC
SHEATH
(12)
(2)
(16)
GROUND
PLASTIC
(14)
(15)
TERMINAL
SHEATH
(STYLE 1 ONLY)
(18)
(15)
(2)
PLASTIC
(20)
SHEATH
Rev. 07/07
Clamp Insert - Small
Clamp
FIGURE 5
CABLE DIAMETER RANGE FOR 200 AMP
AMPERES
(17)
FIGURE 6
Portable Cable
4-Conductor
CONNECTOR
Equipment grounding
(19)
connected to plug shell
STYLE 1 units ground the portable device and the
connector via the grounding conductor and the
plug shroud to the inlet detent spring clips and
housing. The inlet is grounded by virtue of its be-
ing an integral part of the conduit system. All con-
tacts are current carrying.
Clamp Guide
Clamp Insert - Large
Clamp Screw
INSERT TO USE
Small & Large
Large Only
Neither
"Inner
Layers"
PLUGS & CABLE CONNECTORS
Cable Gaging Strip
CABLE DIA. RANGE (IN.)
200
1.00-2.50
STYLE 1
Portable Cable
4-Conductor
INLET
CONNECTOR
Equipment grounding
Grounding thru
connected to plug shell
conduit system
STYLE 2 units have an extra (grounding) contact which
forms a parallel circuit with the circuit formed by the
shroud and inlet detent spring clips.
FIGURE 4
CABLE DIA. RANGE (IN.)
1.00-1.50
1.50-2.00
2.00-2.50
"SOLID" Side
"Inner Layer"
Pushed
Thru and Removed
UseTo Determine
How Many "Inner
Layers" Are To
REMAIN.
STYLE 2
INLET
4th grounding)
wire, if desired
Grounding
Factory installed
thru conduit
grounding strap
system
Publicité
