Sears Kenmore 110.20232710 Guide D'utilisation Et D'entretien page 9

7.
Select WATER LEVEL
Set the Water Level knob to the Auto Sensing setting and the
washer will fill to a level that ensures the load engages the
agitator. From this point, the electronic control will sense the load
and determine if additional water is needed.
Set the Water Level knob to the Deep Fill setting and the washer
will fill to the maximum water level. This option is not available
on Normal wash cycles.
NOTE: E xpect longer wash cycle times due to extended fill times
when using the Deep Fill option.
8.
Select WASH TEMP
Select the Wash Temp by turning knob to desired temperature. All
rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
Wash Temp
Hot
Some cold water is added
to save energy. This may be
cooler than your hot water
heater setting.
Warm
Some cold water may be
added, so this will be cooler
than what your previous washer
provided.
Cool Lights
Warm water is added to assist
in soil removal and to help
dissolve detergents. Cool is
slightly warmer than cold.
Cool Darks
Warm water is added to assist
in soil removal and to help
dissolve detergents. Cool is
slightly warmer than cold.
Cold
Warm water may be added
to assist in soil removal and to
help dissolve detergents.
9.
Press START/PAUSE/Unlock Lid
to begin wash cycle
Press the START/PAUSE/Unlock Lid button to start the wash
cycle. When the cycle has finished, the Cycle Complete
status light will light. Promptly remove garments after cycle
has completed to avoid odor, reduce wrinkling, and rusting of
metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/PAUSE/Unlock Lid; the lid will unlock once the
washer movement has stopped. This may take several minutes
if the load was spinning at high speed. Then close lid and press
START/PAUSE/Unlock Lid again to restart the cycle.
NOTES:
Washer will not fill with the lid open.
■
If your washer does not have a soak option, then pause
■
your washer to soak by pressing the Start/Pause button.
Soaking should be done with the lid closed. When you are
done soaking, press the Start/Pause button to bring washer
out of Pause and resume the cycle.
IMPORTANT: If lid is left open for more than 10 minutes, the
water will pump out automatically.
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed or fade
Light soils
Dark colors that bleed or fade
Light soils
Dark colors that bleed or fade
Light soils
9