Sears Kenmore 110.20232710 Guide D'utilisation Et D'entretien page 16

If you experience
Washer not performing as expected (cont.)
Odors
Lid locked light is
flashing
Single-dose laundry
packet not dissolving
Washer pumps out water
before finishing cycle
16
TROUBLESHOOTING
First try the solutions suggested here
for assistance and to possibly avoid a service call.
Possible Causes
Monthly maintenance not done as
recommended.
Using too much detergent.
The lid is not closed.
A cycle was stopped or paused using
the START/PAUSE/Unlock Lid button.
Adding laundry packet incorrectly.
Lid is left open for more than
10 minutes.
See "Washer Care" in Washer Maintenance.
Unload washer as soon as cycle is complete.
Be sure to measure correctly. Always follow the manufacturer's
directions.
See "Washer Care" section.
Close the lid. The washer will not start or fill with the lid open.
The washer may still be spinning. The lid will not unlock until the
basket has stopped spinning. This may take several minutes if
washing large loads or heavy fabrics.
Be sure laundry packet is added to washer basket before adding
clothes. Do not add packet to dispenser. Follow the manufacturer's
instructions to avoid damage to your garments.
Make sure lid is closed before starting a cycle and/or during
prewash (soak).
Solution