Troubleshooting - ICEluxe P14 Serie Manuel De L'utilisateur

Troubleshooting

Do not repair or disassemble the air conditioning by yourself. Unqualified repair will lead to
failure of the warranty card, and may cause damage to users or their properties.
Problems
The air
conditioning
does not work.
The cooling
effect is not good
Big Noise
compressor does
not work.
The remote
control does
not work.
Displays 'E1'.
Displays 'E2'
Note: If problems not listed in the table occur or recommended solutions do not work, please
contact the professional service organization.
Reasons
There is no electricity.
The overflow indicator displays "FL". Discharge the water inside.
The ambient temperature is too low
or too high
In cooling mode,
temperature is lower than the set
temperature; in heating mode, the
room temperature is higher than the
set temperature.
In dehumidification
ambient temperature is low.
There is direct sunlight.
Doors or windows are open; there are
a lot of people; or in cooling mode,
there are other sources of heat.
The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed on
a flat surface.
Overheat protection starts.
The distance between the machine
and the remote control is too far.
The remote control is not aligned with
the direction of the remote control
receiver.
Batteries are dead.
The pipe temperature sensor is
abnormal.
The room temperature sensor is
abnormal.
Solutions
Turn it on after connecting it to a
socket with electricity.
Recommend to use the machine in at
the temperature of 7-35ºC (44-95ºF).
the room
Change the set temperature.
The machine is placed in a room with
mode, the
an ambient temperature of greater
than 17ºC (62ºF).
Pull the Curtain.
Close doors and windows, and add
new air conditioning.
Clean or replace the filter screen.
Clear obstructions.
Put the air conditioning on a flat and
hard place (to reduce noise).
Wait
temperature is lowered, and then
restart the machine.
Let the remote control get close to
the air conditioning, and make sure
that the remote control directly faces
to the direction of the remote control
receiver.
Replace batteries.
Check the pipe temperature sensor
and related circuitry.
Check the room temperature sensor
and related circuitry.
27
for 3 minutes until the