Operating Instructions; Maintenance - PANCONTROL PAN VOLTFINDER Manuel D'instructions

Function
AC voltage (50/60 Hz)

7. Operating Instructions

Note: Before each measurement check the correct funktion at a known
power source.
1. Switch on the device. (Button 2)
2. Place the probe tip close to the circuit to be tested.
3. If an AC voltage is applied on the object to be measured, the LED flashes in
the top and a signal tone sounds. (12 V to 1000 V)

8. Maintenance

Only authorized service technicians may repair the instrument.
Changing the battery(s)
If the device does not respond during the function test replace the battery.
1. Unscrew the cap (5).
2. Replace the batteries. Mind the correct polarity.
3. Close the battery compartment again.
4. Disposal of the flat battery should meet environmental standards.
EN 6
Range
12 V - 1000 V