Led Indicators; Description Of Functions - IVT DSW-300/12 Notice D'utilisation

•
Operate fluorescent tubes only in conjunction with this voltage converter if they are equipped with an
electronic starter or electronic ballast. Using conventional starters may lead to severe damage of the
voltage converter.
•
AC outputs of several power sources may not be connected in parallel! Do not connect AC generators or
mains voltage to the AC output of the voltage converter. This leads to the immediate destruction of the
voltage converter!
•
Never open the voltage converter! Even after disconnecting the device from the battery there may be
hazardous voltages in the interior of the device. This is why service and repairs may only be carried out by
authorized and qualified personnel.
Warning: Improper assembly may cause hazardous contact voltages even on the closed device!
Notes on the battery
•
If used improperly, lead batteries are a high risk for humans, animals and the environment. Always
observe the safety instructions of the battery manufacturer!
•
Lead batteries contain aggressive corrosive acids. Avoid eye and skin contact with liquids from the battery!
Never disassemble lead batteries! Wash the parts of the skin affected thoroughly with water and soap. If
acid enters the eye, immediately flood the eye with running, clear and cool water! Then seek medical help
immediately! If acid contacts your clothing, wash immediately with soap and water!
Operation and display elements
1. Connection terminals 12V/24V DC input
2. Switch without configuration
3. On/Off switch, standby function
4. Switch for addresses, assignment for remote control FB-
02 or FB-03
5. Switch for addresses, assignment for remote control FB-
02 or FB-03

LED indicators

The LED control indicators 9 (DC input) and 10 (AC output) provide important information on the operating status of your
converter. Both LEDs work independently from one another. I.e., a failure in the DC input area has direct impact on the function
of the AC output; or a failure in the output area affects the input function directly.
Operating status/ fault indicators
Device is switched on and ready for operation
Early warning for deep discharge protection
Cut-off due to deep discharge protection
Input overvoltage
Output short-circuit or overload

Description of functions

The voltage converters of the DSW series are modern, microprocessor-controlled devices which were developed for mobile
power supply. The voltage converters of the DSW series convert lower DC input voltage into higher AC output voltage and thus
allow for the usage of conventional 230V AC consumers on the road.
These devices offer real sinus alternating voltage which allows for a trouble-free operation also of difficult consumers such as
PCs, TV systems and devices with transformers.
Of course, all devices of the DWS sinus voltage converter series are equipped with all necessary safety features which
correspond to a state-of-the-art product.
6. Connector for remote control FB-02 or FB-03
7. Connector for remote control FB-01
8. On/Off switch
9. LED control indicator for DC input
10. LED control indicator for AC output
11. USB output
12. 230V AC output
LED 9 (DC input)
LED is on (green)
Slow blinking (green)
Fast blinking (green)
Fast blinking (green)
Fast blinking (green)
LED 10 (AC output)
LED is on (green)
LED is on (green)
Fast blinking (green)
Fast blinking (green)
Fast blinking (green)