Establishing The Connections - Oase FiltoClear 5000 Mise En Service

Burying the pressure filter
A buried container is barely visible. The stone grey FiltoCap (Art. No. 77831) cover available as an
accessory for the filter cover fits seamlessly into the pond scape.
• Dig a hole close to the pond and place the container in the hole down to the maximum burying
depth.
• The ground must be firm and horizontal.
Installing the pressure filter on level ground
If you choose not to bury the pressure filter, position it so that it is hidden from sight e.g. cov-
ered by bushes.
• Install the unit near the pond.
• The ground must be firm and horizontal.

Establishing the connections

 D
Hoses with a diameter of 38 mm or 50 mm can be connected to the pressure filter. The respec-
tive hose connectors are part of our scope of delivery.

Use hoses with a diameter of 50 mm to keep the pressure losses in the hoses as low as pos-
sible.

If you use a filter starter for start-up, fill the product into the container prior to carrying out
the following installation steps.
− It is easier to remove the filter cover if you first remove all hoses from the filter cover.
Connecting the inlet
Only use pressure hoses approved for at least the maximum pump pressure to connect the out-
let of the filter pump and the inlet of the pressure filter.
• Always use a hose clip to fasten the hose on a hose connector.
FiltoClear
5000
13000
19000
31000
Burying depth h
0.12 m
0.24 m
0.36 m
0.48 m
EN
19