Important - DeWalt DW979 Guide D'utilisation

Masquer les pouces Voir aussi pour DW979:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DW979,159361-02,00
5/8/02
This is important and will prevent serious damage to the battery
pack.
2. The charger and battery pack may become warm to touch while
charging. This is a normal condition, and does not indicate a
problem.
3. The 15 Minute charger has an internal temperature limit that, when
exceeded, will temporarily stop the full charge current. This is
indicated by the yellow light being ON. The normal charge cycle
will resume when the temperature falls below the preset limit and
will be indicated by the yellow light turning OFF. The charge time
may be extended beyond the normal 15 minutes. Use the charger
in normal room temperatures whenever possible. To prevent
overheating, do not cover the charger and do not charge battery
packs in direct sunlight or near heat sources.
4. If the battery pack does not charge properly — (1) Check current at
receptacle by plugging in a lamp or other appliance, (2) Check to
see if receptacle is connected to a light switch which turns power off
when you turn out the lights. (3) Move charger and battery pack to
a location where the surrounding air temperature is approximately
65°F - 75°F (18°- 24°C). (4) If charging problems persist, take or
send the tool, battery pack and charger to your local service center.
5. The battery pack should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO
NOT CONTINUE to use under these conditions. Follow the
charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
6. Under certain conditions, with the charger plugged in to the power
supply, the exposed charging contacts inside the charger can be
shorted by foreign material. Foreign materials of a conductive
nature such as, but not limited to, steel wool, aluminum foil, or any
buildup of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply when
there is no battery pack in the cavity. Unplug charger before
attempting to clean.
9:56 AM
Page 5
7. Do not freeze or immerse charger in water or any other liquid.
8.
WARNING: Don't allow any liquid to get inside charger. Electric
shock may result. To facilitate the cooling of the battery pack after
use, avoid placing the charger or battery pack in a warm
environment such as in a metal shed, or an uninsulated trailer.
9.
CAUTION: Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.

Important!

This product is not user servicable. There are no user servicable parts
inside the charger. Servicing at an authorized service center is required
to avoid damage to static sensitive internal components.
READ ALL OF THE INSTRUCTIONS IN THE BATTERY CHARGER
SECTION OF THIS MANUAL BEFORE ATTEMPTING TO CHARGE
THE battery pack FOR YOUR TOOL.
Always use correct battery pack (pack supplied with tool or
replacement pack exactly like it.) Never install any other battery pack.
It will ruin your tool and may create a hazardous condition.
DEPRESS FOR REVERSE
TRIGGER
SWITCH
CENTER POSITION: LOCKED
5
DEPRESS FOR FORWARD
FIG. 4

Publicité

Table des Matières
loading

Table des Matières